The Mineshima 0.3 mm modeling drill bit is intended for drilling the finest holes and details in a pin vise.
Responsibility details are not available.
A single twist modeling drill bit of 0.3 mm diameter for drilling very fine holes in plastic, resin, wood and soft metals. It is best used in a pin vise, where you have full control over the speed and the pressure and there is no risk of overheating or tearing the material as with power tools.
For modelers focused on fine detailing who need very small, accurate holes. Because of its small diameter the bit is fragile and calls for a delicate touch.
Thin drill bits are fragile, so drill slowly, straight and without side pressure so that they do not break. A pin vise is not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
