Revell masking tape, 10 mm wide, 10 m on the roll - a narrower modeling tape that follows curves and smaller parts well. A modeling supply, not a kit.
Responsibility details are not available.
A modeling masking tape 10 mm wide with 10 meters on the roll from Revell. It is used to cover areas cleanly that are to stay untouched while painting. The manufacturer recommends it for painting with a brush, with a spray can and with an airbrush. It is not a model and not an accessory to a model - it is a modeling supply, a consumable for painting.
Ordinary household adhesive tape is unsuitable for models. Its adhesive is too aggressive and on removal it pulls off the paint and the primer you laid down with such effort. Modeling tape has a lower, controlled tack - it grips enough to keep paint from creeping underneath, yet it comes off cleanly, with no adhesive residue and no damage to the surface below. The second difference is the edge: modeling tape is cut crisply and straight, so the transition between two colors is a clean line rather than a ragged border.
Stretch the tape lightly around curves and press it down as you go - the inner side gathers slightly, but the edge stays straight. Always press down firmly on the edge where the color transition will run. Spray thinly and straight on, not at a sharp angle in under the tape. Take it off before the paint has fully cured and pull it back over itself at a shallow angle.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
