0.7 mm Nut with bolt shank is a set of imitation nuts with a projecting bolt shank of 0.7 mm size. It suits joints where the end of the bolt reaches above the nut.
Responsibility details are not available.
An accessory for modelers who want the screw joints on a model to be truly three-dimensional. The part combines a nut and the projecting end of a bolt, that is the detail hardest to make by hand and yet clearly visible in visible places. The 0.7 mm size is a step more pronounced than the finest version of the range, so it suits joints that are to be distinct even at a distance.
The 0.7 mm size corresponds in 1:35 scale to roughly 25 mm of real size, in 1:48 to about 34 mm and in 1:72 to approximately 50 mm. In the large scales it is an ordinary size of engineering joint, and in the small ones a pronounced feature. The manufacturer also makes the same type of part in the sizes 0.5, 1, 1.2 and 1.5 mm.
It will be appreciated by builders of vehicles who refine chassis, hinges, flanges and brackets, and by modelers who need to restore joints after repairing or altering a part. The work is small, so count on tweezers and good light.
The accessory is supplied unpainted. Glue, paints and a pin vise are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
