Aires Fouga Magister flaps - closed 1:48 - a resin set of landing flaps in the retracted, closed state for a model of the Fouga Magister trainer in 1:48 scale.
Responsibility details are not available.
A resin set of landing flaps from Aires. It replaces the flaps of a plastic kit with a more accurate casting in the retracted, closed state, that is as they look in flight. It is an accessory for more experienced modelers, built into a base model of the Fouga Magister in 1:48 scale.
The Fouga CM.170 Magister was a French two-seat jet trainer of the 1950s. It stood out for its butterfly V-tail and became one of the first jet trainers built in series. It served in a number of countries for pilot training and in some cases on light combat tasks as well.
First wash the parts to remove any mold release agent, cut off the casting blocks and clean up the mating surfaces. Bond with super glue (cyanoacrylate) and protect your airways while sanding resin. Lay down a primer before painting; the engraving and the transitions of the wing blend better into one surface with the set in place.
This is a resin accessory for a kit, not an airplane model. It is supplied unassembled and unpainted; the base model, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
