An accessory connector for a modeling workbench with a 30 degree angle. The system it belongs to is given in the manufacturer's instructions.
Responsibility details are not available.
A modeler does not lay out a work place once and for all. Tools, bottles and a build in progress move about according to what is on the bench at the time, and the arrangement around them changes accordingly. Connectors are therefore usually made as separate parts that can be added later. This part joins pieces of the arrangement at an angle of thirty degrees, that is at a slant rather than at a right angle. A slanted join suits cases where the arrangement is to surround the place where the work is done, so that the modeler can reach everything without turning the whole body.
This is a single accessory part, not a finished organizer. For it to be of any use, it has to connect to an arrangement it is dimensionally compatible with. Before ordering, check against the manufacturer's instructions which arrangement the part belongs to and how it attaches to it.
It pays to keep to a simple rule: what you use most often should be within arm's reach without standing up, and free space for light has to stay above the model in progress. Do not put the arrangement in the middle of the top, then, but round the edge of the work surface. Wipe the parts regularly, as dust settled from the bench and abrasive residue otherwise end up on fresh paint.
The other parts of the arrangement, tools and paints are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
