Turned imitations of hexagonal bolt heads measuring 1.34 x 1.60 mm, 30 pieces in the package. A replacement for the soft shapes of fasteners on a model.
Responsibility details are not available.
Bolts and nuts are among the details that give away the scale of a model at once. Molded or sanded heads tend to be rounded and blurred, whereas a turned part has sharp hexagon edges and a regular outline all the way round. That is exactly what shows from close up in a photograph and under a magnifier, because light breaks differently on a sharp edge than on a rounded shape.
Thirty turned imitations of hexagonal heads measuring 1.34 x 1.60 mm. The size is given in millimeters, so you can easily check against the scale of your model how large a fastener on the real thing it corresponds to. The set is not tied to one kit; you will use it anywhere the surface lacks convincing bolt heads.
First cut the original shape off the model carefully with a sharp blade and level the area with a fine abrasive. Set the new part into a pre-drilled hole, or glue it straight onto the surface with cyanoacrylate glue applied in a tiny amount, ideally on the tip of a wire. The parts are small, so work with tweezers over a tray with a raised rim, and wash and degrease the surface before painting so that the paint holds.
For modelers who are fine-tuning the surface of equipment, engines or chassis and want their fasteners sharp. Glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
