Pre-cut self-adhesive painting masks A-7A Corsair II 1:48 from the Czech manufacturer Eduard. This is not a model — it is an accessory for painting the canopy glazing and the wheels cleanly.
Responsibility details are not available.
A set of precisely pre-cut self-adhesive painting masks from the Czech manufacturer Eduard for a model of the American LTV A-7A Corsair II carrier-based attack aircraft in 1:48 scale. It is not a kit and it is not a model — it is an accessory that makes it easy to paint the canopy glazing and other small areas cleanly. The masks stick straight onto the parts, so the framing of the single-seat canopy gets sharp, straight edges without any laborious cutting of masking tape. Sets of this type usually also include circular masks for the wheel rims, which make it easier to separate the tire from the rim.
The LTV A-7 Corsair II was an American carrier-based subsonic attack aircraft developed for the US Navy as a carrier of bombs and rockets with long range and good accuracy. The A version was the initial production model and saw combat over Vietnam. Its rugged airframe with a short fuselage and a wide air intake under the nose is topped by a one-piece canopy, which is where the masks save the most work.
Lift each mask off the backing carefully with tweezers or the tip of a knife and lay it on a dry, degreased surface. Press the edges down firmly so that paint cannot bleed underneath. Apply the paint in thin coats, ideally with an airbrush, and pull the mask off before the coat hardens completely. On strongly curved shapes it helps to seal the edge with masking fluid.
This is a set of painting masks, not a model. The kit, paints and glue are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
