Photo-etched steel seat belts for the cockpit of an A-10C Thunderbolt II model in 1:48 scale.
Responsibility details are not available.
A set of seat belts for a model of the A-10C Thunderbolt II attack aircraft in 1:48 scale. According to the name, the STEEL designation says what the belts are etched from: steel, not a softer alloy. The exact number of parts and their color finish is given in the enclosed manufacturer's instructions.
Steel holds its shape. A belt bent over the edge of a seat, or thrown loosely over the side of the cockpit, stays exactly where you put it and does not straighten out again. That is what matters with belts, because a natural sag and a carelessly dropped end turn an empty seat into a place where somebody was sitting a moment ago. On top of that, the belts are the first thing the eye notices in an open cockpit.
Separate the parts from the fret with a sharp blade on a hard surface and sand the burrs lightly away. Shape the belts gradually, bend by bend, ideally with flat-jawed tweezers. They are glued with cyanoacrylate glue applied in a tiny amount so that it does not run over the edge. If you are going to paint the belts, degrease the surface first and apply a primer.
The set suits anyone building the A-10C with an open cockpit who wants to refine it. Check in the instructions which 1:48 kit it is developed for. The kit, paints and glue are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
