Dead Design 1:72 B-25B Mitchell canopy mask is a masking set for the glazing of a model of the twin-engine bomber North American B-25B in 1:72 scale. It covers the glazed areas that are the worst to mask on a bomber. Target kit: Airfix.
Responsibility details are not available.
A masking set for the glazing of a model of the B-25B Mitchell in 1:72 scale. On a bomber masking is an incomparably bigger piece of work than on a fighter - there are more glazed areas, they are in various places on the airframe and each one has a different shape of frame. It is precisely here that ready-made masks pay off the most. The masks are cut for the Airfix kit.
The North American B-25 Mitchell was a twin-engine medium bomber with nose landing gear and twin vertical tail surfaces. The B-25B version had a glazed nose for the navigator and a rotating gun turret above the fuselage. In shape it is an aircraft on which the glazing cannot be got around or left out during the build - it is visible from every angle.
Reckon with the fact that with this set you will spend more time over the cabin and the nose than with a single-seat fighter. The glazing of the nose has a lot of small panes and the frame between them is really thin in 1:72 scale, so do not set about it without tweezers and good light. Proceed one pane at a time, lay every mask straight into place and only then press it down - sliding it over the surface is the quickest way to a creased mask. After sticking them on, go over the edges with a toothpick. Spray the paint in thin coats; a thick coat will make a noticeable step on that many edges.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
