29.–30. 10. z technických důvodů zavřeno. / Closed 29–30 October for technical reasons.
1:72 Gloster E28/39 Pioneer for CP kit painting mask

1:72 Gloster E28/39 Pioneer for CP kit painting mask "yellow kabuki paper"

3.56 €
Add to Cart

1:72 Gloster E28/39 Pioneer for CP kit painting mask "yellow kabuki paper"

The 1:72 masking set for the Gloster E28/39 Pioneer is a sheet of pre-cut self-adhesive masks from yellow kabuki paper, cut for the kit of the same manufacturer. It is not a model but an accessory for clean spraying of the color transitions.

Scale1:72
Manufacturer Clear Prop Models
Product EAN8591111000000

Responsibility details are not available.

4.76 € 3.56 €
2.94 € without VAT
−25 % You save 1.20 €
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

1:72 masking set for the Gloster E28/39 Pioneer (Clear Prop Models)

This is a set of pre-cut self-adhesive masks in 1:72 scale, not a kit. According to the name, the masks are cut from yellow kabuki paper and they are cut for the kit of the same manufacturer, so that the outlines fit the parts without additional shortening and trimming. The point of the set is to get sharp edges of paint by spraying, not by drawing around the frame of the glazing by hand with a brush.

The real subject

The Gloster E.28/39, nicknamed Pioneer, was the first British aircraft with jet propulsion. It first flew in May 1941 and served solely to prove the engine designed by Frank Whittle; it never entered service armament. It was a small single-seat all-metal low-wing monoplane with retractable nose gear and with an intake opening in the nose, from where the air continued through ducts around the cockpit to the engine at the rear.

Usage tips

First degrease the glazing and let it dry perfectly. Lift the mask off the sheet with tweezers or the tip of a scalpel, lay it on dry and only then press down the center first and the edges last. The most common cause of paint running under is exactly an edge that was not pressed down, not the wrong paint. Spray in several very thin coats, and preferably at a right angle to the edge of the mask, so that the paint is not pushed under it. Peel the mask off while the paint has set and not yet cured completely, otherwise there is a risk that the film of paint will tear away with the tape. Store the unused part of the sheet flat, in the dark and dry.

Who the set is for

  • modelers who want a sharp glazing frame without drawing around by hand
  • builders of the kit of the same manufacturer in 1:72 scale
  • those who paint with an airbrush and want to save time with taping
  • anyone interested in early jet aircraft

The package holds only the masks. The kit, paints and glue are not included.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

No. It is a masking set, that is an accessory to a kit already bought. The model itself and the paints are not in the package.

The set is cut for a particular kit of the same manufacturer. On another model the shapes need not match, so verify before purchase that you are building the corresponding kit.

Ideally shortly after spraying, when the paint has set but not yet cured completely. On fully cured paint the edge breaks less well and the film of paint can tear away too.

Press the edges of the mask down thoroughly, spray several very thin coats and aim at a right angle to the edge, not at a sharp angle.

Last seen

1:72 Gloster E28/39 Pioneer for CP kit painting mask -25 %Stock ClearanceFavorite
Clear Prop ModelsCPA720501:72

1:72 Gloster E28/39 Pioneer for CP kit painting mask "yellow kabuki paper"

The 1:72 masking set for the Gloster E28/39 Pioneer is a sheet of pre-cut self-adhesive masks from yellow kabuki paper, cut for the kit of the same manufacturer. It is not a model but an accessory for clean spraying of the color transitions.
10 left
4.76 €3.56 € You save 1.20 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.