Brass pipes 2.2 mm (2 pcs) from AK interactive are hollow brass sections for scratch-building and for detailing plastic models.
Responsibility details are not available.
A package of two hollow brass pipes with an outside diameter of 2.2 mm. It is a modeling material for scratch-building, not a kit. Brass cuts, bends and solders well, and hollow pipes will serve as exhausts, pipework and heavier barrels.
Cut with a fine saw or with a snap-off knife while rotating and clean the ends up; on barrels, drill the muzzle out lightly. The thinner pipes from the range can be telescoped inside. Bond with cyanoacrylate glue (super glue) or solder; before painting, degrease the brass and apply a metal primer.
This is raw material, not a finished part. Clean up the sharp ends after cutting. Glue, paints and tools are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
