Cutting pliers pattern 2

Fine Art cutting pliers pattern 2

Fine Art cutting pliers pattern 2 are precise modeling nippers intended for separating plastic parts from the sprues of kits. The thin, finely ground cutting edge lets you cut right up against the part and leaves a clean cut that then takes only minimal work to sand down. The pattern 2 designation refers to the form of the cutting edge within the Fine Art range of pliers.

Use

• Separating plastic parts from the sprue right up against the part
• A clean cut with a minimum of flash and white stress marks after cutting
• Work on plastic kits and small parts
• Worth pairing with a cutter or a file to clean up the remains of the sprue gate
• Intended for plastic; do not cut hard wire or metal parts

Who they are for

For modelers building plastic kits who want to separate parts from the sprues cleanly and accurately and save themselves the cleaning up afterwards. Beginners and advanced modelers alike who care about the quality of the cut will appreciate them.

A tool with a sharp cutting edge: handle it carefully, do not point your fingers at the edge and store it out of the reach of children. Use the pliers on plastic only; cutting metal or hard material will damage the edge.