Amazing Art mini modeling drill bits 0.3 to 1.6 mm are a set of small twist bits for a pin chuck. The manufacturer gives 20 pieces held in a plastic case with the diameters marked.
Responsibility details are not available.
A set of small twist bits for precise work on plastic models. The manufacturer gives 20 pieces in diameters from 0.3 to 1.6 mm held in a plastic case where the size is marked at each position, so you find the diameter you need without measuring. The package holds the bits themselves; a pin chuck for them is not listed by the manufacturer in the contents.
For modelers who detail cockpits, landing gear and armament, and for beginners who have run out of the single bit supplied with a hand drill. The bits are held in an ordinary pin chuck. Lead the thinnest diameters at right angles and without side pressure, tap the chips out as you go, and on smooth plastic mark the spot with a point first, so the bit does not slip. Thin bits are more likely to break than to bend, so work slowly and let the tip itself do the cutting. If you need a hole trued up to its axis, drill with a smaller diameter first and only then open it out.
Safety note: the bits are sharp and very small. Keep them in the case and out of the reach of children, and protect your eyes when drilling with a power tool.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
