A resin kit part, a long pipe connector (the OUT-OUT type), from MAiM. Part of a modular tube system for industrial dioramas.
Responsibility details are not available.
A resin kit part from MAiM out of the modular tube system for building pipe runs in a diorama. This piece is a long connector of the OUT-OUT design, that is with an external end at both ends, used to join two consecutive pipe sections. The part is compatible with ordinary plastic (styrene) tubes of the matching diameter and rounds out the straight sections, bends and end caps in the range. It is not a figure or a model of equipment but a scenic accessory. It is supplied unassembled and unpainted.
The connector joins two pipe sections and at the same time gives the run a realistic joint with a flange or a collar. The long design bridges a greater gap between parts and suits anywhere pipework continues into a further section. With ordinary plastic tubes and the other parts of the system you can extend the run as you like.
Wash the parts in lukewarm water with detergent, clean up the seam lines and bond them with super glue. Apply a primer before painting. Bring the metal out in gray, green or rust as you intend, and on the edges add chipping, traces of rust and a wash to pick out the joints and the flanges.
The accessory is supplied unassembled and unpainted. Glue, paints, plastic tubes and a base are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
