Czechoslovak pilots on the Il-2M3 – 1:32 is a set of wet decals from AML for models of the Ilyushin Il-2M3 attack aircraft in the colors of Czechoslovak airmen on the Eastern Front.
Responsibility details are not available.
A set of waterslide (wet) decals in 1:32 scale focused on the two-seat Ilyushin Il-2M3 attack aircraft flown by Czechoslovak airmen on the Eastern Front. It lets you build a model with the markings of this less common chapter of Czechoslovak military history. Painting masks are usually included with the AML series. This is not a kit but an accessory for the plastic model of your choice.
The Ilyushin Il-2 Shturmovik was the most widely built attack aircraft of the Second World War. The Il-2M3 version had a two-seat cockpit with a rear gunner and swept, cranked wings for better handling. The heavily armored fuselage protected the pilot and the engine during low-level attacks on ground targets. Czechoslovak airmen flew these machines with the units fighting alongside the Red Army in the closing stage of the war.
Apply the decals over a smooth gloss coat so that no silvering appears. Dip the cut-out part briefly in lukewarm water, slide it off the backing onto the model, adjust its position and blot the excess water away. Use a decal softener to make it cling to the engraved lines and seal the surface with a final clear coat. Stick the enclosed masks onto a clean coat and spray the paint over them.
This is a stand-alone decal set. The model, paints and glue are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
