Flat Rivet 0.9 mm are modeling rivets with a flat head of 0.9 mm from the GAS HANS brand. They are among the finer sizes in this sub-range.
Responsibility details are not available.
Rivets with a flat head in the 0.9 mm size from the range of small modeling material of the GAS HANS brand. A flat head is the most discreet of the shapes offered: on the surface it creates only a thin disc, which shows chiefly thanks to the shadow around its edge. It is not a kit and not a part for a particular model, but an add-on material to be seated on the parts of your own build.
The 0.9 mm size already calls for fine tweezers, good lighting and a steady hand; tiny parts are easily lost, so work over a surface with a raised edge. Sand the surface beforehand and get the dust off it so that the head seats on its whole underside. Because the relief is low, beware of heavy coats of paint: spray in thin layers, otherwise the heads will be flooded and will disappear. A wash that traces the edge brings them out best, or else a very fine dry brush.
For modelers who work with finer detail and want rivet heads in several shapes and sizes to hand. It will serve when building equipment, on conversions and when making your own parts, where a coarser rivet would break the scale.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
