The full photo-etched set 1:32 A6M5 Zero interior from Eduard brings color-printed parts of thin metal into the cockpit, including the instrument panel and the seat harness.
Responsibility details are not available.
At Eduard the 32 code series means a full photo-etched set, that is not a reduced selection. Into the cockpit of the large Zero it brings parts of thin metal sheet whose visible side is printed in color from the factory, dials included. They replace the instrument panel, the side panels, the controls and the multi-part seat harness, that is the shapes that necessarily come out coarse in plastic at this scale.
The cockpit of the A6M was built for low weight, so the structure stayed largely exposed and with the canopy slid back you can see deep inside. That is at the same time the reason why it pays to finish the interior on a large-scale model: without any work it looks empty, while with photo-etch it offers depth and legible instruments. For the same aircraft the manufacturer also offers a considerably smaller Zoom variant, and the difference between the two items lies precisely in the scope.
Cut the parts off on a hard surface, make the bends in a bending tool or between two blades, and glue with cyanoacrylate applied with a pin. Do not spray the printed surfaces over with a flat varnish across the whole area, because they will lose contrast. Degreasing the unprinted parts before gluing increases the strength of the joint.
The contents are photo-etched sheet, and the plastic parts of the aircraft are bought separately.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
