1:35 Armored exhaust cover for Tiger I initial, early, mid and late, without casting no. , for 2 vehicles, Dragon kits

ELEFANT 1:35 armored exhaust cover for the Tiger I, without a casting number

A 3D-printed (resin) replacement set of armored exhaust covers from the maker Elefant in 1:35 scale. The covers fit models of the Tiger I heavy tank across its versions, from early through mid to late. This variant has a surface without a raised casting number. The package covers two vehicles.

The real subject

The Tiger I had the exhaust pipes on the rear of the hull protected by armored covers, which shielded them from damage and from splinters. Finely rendered covers are a striking part of the silhouette of the tank's rear. The real covers also differed in whether they carried a raised foundry number on the surface, and it is that small point which the difference between the variants of the set concerns.

Use and tips

• Cut the parts from the print supports and clean them up with respiratory protection.
• Clean off any residue before gluing.
• They are bonded with super glue (cyanoacrylate).
• Accent them with rust and dust pigments for a faithful look.

Who the set is for

• Builders of Tiger I models in 1:35 scale across the versions.
• Modelers who want smooth exhaust covers without a casting number.

This is an add-on detail set, not a tank model. The base model, glue and paints are not included in the package, unless stated otherwise.