1:48 F4F-3 Wildcat is a set of masking templates for the glazing of the cabin from Dead Design. The Wildcat has a canopy divided by a multitude of narrow bars, and it is precisely with a frame like that that masking by hand most often fails.
Responsibility details are not available.
Pre-cut templates from the manufacturer Dead Design follow the frame of the canopy of the carrier-borne fighter Grumman F4F-3 Wildcat. They are stuck onto the clear part, taken off after spraying, and clean glass with a precisely bounded frame is left. It is not a kit nor a replacement clear part, but an accessory to a model.
The Wildcat belongs among the aircraft with a densely divided canopy: between the individual panes, strips only a fraction of a millimeter wide are left in 1:48 scale. Cutting such a network out of self-adhesive tape by hand is possible, but the result tends to be unevenly wide and the individual bars wander. The eye reveals it on a finished model at once, because the frame of the cabin is one of the first places a person looks at. A pre-cut set keeps the width of all the bars uniform.
With a dense frame it sometimes happens that paint gets under one of the narrow templates. It can be corrected, but only after the finish has fully cured. Cut a sharpened wooden stick or a toothpick off at an angle, dip it in water and wipe the excess away carefully by pulling along the bar. Reach for a hard tool only as a last resort, because glass is easily scratched and polishing a tiny area between the bars is thankless work. Prevention is simpler than repair, so spray weakly and seal the edge of the mask in advance with a thin coat of the color of the frame.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
