A photo-etched detail set for a model of the A-10C Thunderbolt II attack aircraft in 1:48 scale.
Responsibility details are not available.
The A-10 Thunderbolt II is an American attack aircraft meant for close support of ground troops. The whole structure is built around a seven-barrel 30 mm cannon and assumes that the machine will be hit: the pilot sits in an armored tub and the controls are duplicated. The C version is a later upgrade with reworked avionics and new cockpit equipment.
Photo-etched parts in thin metal sheet for a 1:48 model of the A-10C. The enclosed manufacturer's instructions are binding. They also give the assembly order and a note on which shapes on the kit are thinned or cut away before the metal is glued on.
Separate the parts from the fret with a sharp blade on a hard surface, then sand the burrs away. Make the bends in a bender or between two blades so that the edge stays straight. They are glued with cyanoacrylate glue applied in a small amount; any excess is hard to get off metal. Wash and degrease the surface before painting and spray it with a primer; otherwise the finish will not hold on smooth metal and rubs off during handling.
The set suits a modeler who has already built with small metal parts and wants to take an A-10C model beyond the contents of the kit. Check in the instructions which particular 1:48 kit it is developed for. The kit itself, the paints and the glue are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
