Eduard 1:48 exhaust nozzles for the Jaguar GR.1 (PRINT) — a 3D-printed resin accessory that replaces the plastic nozzles of the kit. It is not a model, but a detail set for experienced modelers.
Responsibility details are not available.
A 3D-printed resin set of exhaust nozzles for the Anglo-French SEPECAT Jaguar GR.1 attack aircraft. It is an accessory for advanced modelers, not a standalone model: the parts replace the rear engine nozzles from the plastic kit directly and are intended for the Airfix model in 1:48 scale. Direct 3D printing faithfully captures the fine structure of the petals and the inside of the nozzles.
The Jaguar GR.1 was a single-seat supersonic ground-attack aircraft powered by a pair of Rolls-Royce/Turbomeca Adour turbojets. It served with the Royal Air Force from the 1970s as a carrier of conventional and tactical armament for strikes against ground targets. The exhaust nozzles are among the visually exposed areas where the simplified plastic part is usually replaced by a finer accessory.
Wash the parts to remove any print resin residue, release them from the print supports and bond them with super glue (cyanoacrylate). The inside of the nozzles takes a dark base and fine shading of metallic tones well. Protect your airways while sanding.
This is an accessory set, not a standalone model. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
