1:48 Macchi Mc.202 - early wheels & paint masks

1:48 Macchi Mc.202 - early wheels & paint masks

10.80 €
Add to Cart

1:48 Macchi Mc.202 - early wheels & paint masks

Resin wheels of the early type for the Macchi Mc.202 in 1:48 scale with paint masks, from the Aires brand. An accessory for a model, not a kit.

Scale1:48
Manufacturer Aires
Product EAN8591111000000

Responsibility details are not available.

10.80 €
8.93 € without VAT
3 pcs in stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Aires, early-type wheels and masks for the Macchi Mc.202, 1:48 scale

This item is a resin accessory for a model of the Italian Macchi Mc.202 fighter in 1:48 scale, not a kit. It replaces the main gear wheels with castings of the early type and adds masks that make it easier to separate the paint of the tire from the hub. Cast wheels have the advantage over plastic parts that they tend to be made as weighted tires, so the model stands on the ground convincingly and does not look as though it were floating.

The real subject

The Macchi Mc.202 Folgore was an Italian single-seat fighter of the Second World War, created by fitting a liquid-cooled V engine into the airframe of an older type that had a radial. The result was a slim aircraft with markedly better flying qualities. The gear wheels differed during production and service in the pattern of the hub and of the tire, and that is exactly why an early and a later type are distinguished. For the modeler it is a detail worth watching, because a wheel sits at eye level on a finished model.

Usage tips

Wash the castings in warm soapy water, cut the casting block off with a saw and sand the mark it leaves wet, ideally so that it falls into the contact patch of the tire. The wheel then only has to be sprayed with a dark base color, the mask stuck onto the hub and the hub oversprayed with a metal shade or a covering color. Take the mask off while the paint has only just dried rather than cured, because the edge then stays sharp. The tire should not be black: a lighter dark gray with fine dusting looks more natural in 1:48 scale. Glue the wheel onto the model with super glue only after painting, and do not forget to set it so that the flat spot sits level on the surface.

Who the set is for

  • Modelers of Italian fighters in 1:48 scale who are dealing with the correct type of wheels.
  • Those who want a wheel with a weighted tire instead of perfectly round plastic.
  • Builders who cannot cleanly separate the hub from the tire with a brush.
  • More experienced modelers used to resin and super glue.

This is an accessory, not an aircraft model. Kits, paints and glue are not included in the package, unless stated otherwise.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

The wheels on this type differed during production in the pattern of the hub and the tire. The set corresponds to the earlier type.

They serve to cover the hub while the tire is painted, so that a sharp boundary arises between them with no touching up by hand.

It is not. These are only replacement wheels with masks, and you have to have the kit of your own.

Not pure black. A dark gray shade with fine dusting looks more convincing in a small scale.

Last seen

AiresAIR48081:48

1:48 Macchi Mc.202 - early wheels & paint masks

Resin wheels of the early type for the Macchi Mc.202 in 1:48 scale with paint masks, from the Aires brand. An accessory for a model, not a kit.
In stock
10.80 €
Mantis MiniaturesMAN350441:35

1:35 U.S. Marine (Fallujah Iraq 2004)

A resin figure, U.S. Marine (Fallujah, Iraq 2004) , in 1:35 scale from Mantis Miniatures. It shows an American Marine from the fighting for Fallujah in 2004; a kit for advanced modelers.
In stock
15.96 €
HGWHGW1320551:32

1:32 Albatros D.III / D.Va

A set of fabric seat belts, HGW Albatros D.III / D.Va , in 1:32 scale with etched metal buckles. A detail accessory for the cockpit, not a model of an aircraft.
In stock
5.84 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.