Quinta Studio 1:48 OV-10D Bronco is a three-dimensional (3D) interior decal for the twin-engine observation and light attack aircraft in 1:48 scale. Both stations in the glazed cabin thereby gain colored, raised detail. Intended for the ICM kit.
Responsibility details are not available.
This item is an accessory set, not a kit of the aircraft. Quinta Studio prints the interior elements three-dimensionally and already in color onto decal paper, so the instrument panel, the side panels, the controls and the seat belts gain relief and color at the same time. On the Bronco that is especially useful, because the cabin has extensive glazing including the lower panels and very little hides in it. The set is designed for the ICM kit.
The OV-10 Bronco is a twin-engine turboprop aircraft with a pair of tail booms, designed for observation, directing air support and light strikes. The crew sits in tandem under long glazing with an excellent view downward, which was a key feature for its role. The D version is a later form intended also for work in reduced visibility, with the matching sensor equipment and a revised powerplant. Machines of the type served for decades and some of them found a use outside military service too, for example in firefighting and patrol work.
Quinta three-dimensional decals are printed on a decal backing paper: the part is dipped briefly in lukewarm water for about fifteen seconds and slid off the paper. It has no adhesive layer of its own and holds on gloss varnish, so spray the cabin first, let the paint cure thoroughly and go over the surface with gloss varnish; a matte base is a mistake. Do not use a decal softener or a setting solution at all, as their chemicals would damage the printed resin layer. The exact procedure is given in the instructions enclosed with the set. Pick the parts up with smooth-jawed tweezers, lay them down dry, fine-tune the position and only then press them home. Because the cabin is visible from below as well, do not forget the floor and the side walls; unify the whole with a matte varnish at the end.
This is not a kit of the aircraft but an accessory set. The base model, paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
