1:48 Vought F4U-1A Corsair — seat with integral belts (PRINT) from Eduard is a 3D-printed pilot seat with the belts printed directly in the part. According to the manufacturer it is intended for the F4U-1A kit from Magic Factory — it is not a kit, and you have to have the model.
Responsibility details are not available.
A replacement pilot seat for a Corsair F4U-1A model in 1:48 scale, made by direct 3D printing in resin. It is not an aircraft kit but an accessory for the cockpit — the model itself you have to obtain separately. The Corsair cockpit is clearly visible under the sliding canopy and the seat dominates it; a plastic part from a kit can only manage it in simplified form.
According to the manufacturer the set is made for the F4U-1A kit in 1:48 scale from Magic Factory, not for Corsairs from other makers. That is key information: the seat is shaped to a particular cockpit tub, so it may not fit dimensionally into a model from another brand. If you are building a Corsair from a different maker, allow for possible rework or check compatibility beforehand.
The usual route is to glue photo-etched belts of sheet metal onto the seat, which have to be laboriously bent to give the impression of fabric. Here the belts are printed straight in as part of the seat: they have volume, thickness and a natural sag that flat photo-etch can never give, and gluing them falls away. For most modelers that is exactly why they buy the set — the cockpit looks convincing in a few minutes instead of an hour of fiddling with photo-etch.
The PRINT designation means the part was created by direct 3D printing in resin — not by casting, not by injection molding. The result is extremely fine detail (buckles, stitching on the webbing, thin shell edges) and a minimum of cleanup: the part is held on thin supports that separate easily, with no massive casting block. According to the manufacturer the set contains one printed part and colored photo-etched details.
Resin is not glued with cement for polystyrene — reach for cyanoacrylate or epoxy. Wash the part, spray a primer and only then paint. Resin dust is harmful to health: always sand wet, do not breathe it in and ventilate. It pays to paint the webbing separately and finish it with a thin wash — the three-dimensional sag then really comes out.
The accessory is supplied unassembled and unpainted. The aircraft model, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
