Dead Design 1:72 A-7 Corsair II canopy mask is a masking set for the glazing of a Vought A-7 Corsair II attack aircraft model in 1:72 scale. With it the canopy framing can be sprayed without paint running onto the glazing. Intended for the Fujimi kit.
Responsibility details are not available.
A masking set for the glazing of an A-7 Corsair II model in 1:72 scale. The masks are cut to the shape of the individual glazed panes, so the most tedious part of preparing a canopy falls away: cutting tape to the frame with a scalpel. The target kit is Fujimi.
The glazing is masked before the airframe is sprayed. The proven sequence is this: wash and degrease the clear part, apply the masks, glue the part into the fuselage and fill the seams, and only then spray primer and color. If you mask only after the airframe has been sprayed, the tape or the mask may touch the fresh edge of the paint as it comes off and tear it away. Leave the masks on the part throughout painting, including the final varnish, and take them off at the very end, but not after a long delay, because the longer they sit on the part, the harder they are to remove.
The A-7 Corsair II was a subsonic attack aircraft with a turbofan engine, built for precise strikes against ground targets with a large load of ordnance on its pylons. The cockpit has a short windshield and a hinged canopy whose framing is narrow and intricate on a model.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
