1:35 Assorted hands set No.5 is a resin set of replacement hands for figures in 1:35 scale, the fifth part of a numbered series from the Royal Model brand.
Responsibility details are not available.
The number in the name refers to the position within a series that the Italian manufacturer has been expanding step by step. Each part brings a different selection of poses, so the individual sets complement one another rather than replace one another. The castings are resin and in this scale a single piece measures only a few millimeters.
Hands give away a badly built figure sooner than anything else. A mass-produced casting often has them closed around an object that will not be in your scene, or in a position that does not match what the figure is doing. Swapping them for an open palm, a pointing finger or a fist changes the sense of the figure more than repainting the whole uniform.
Cut the original hand off with a saw at the wrist, square to the forearm, level the surface with a file and drill a hole in both parts for a short pin of thin wire. The pin secures both the position and the strength of the joint; super glue on its own would not hold for long on such a small area. Fill the remaining gap with putty and run abrasive paper over it until the transition disappears.
Fasten the small parts to a wooden stick with double-sided tape while you work, so that they do not fly off. Looking for a three-millimeter casting in the carpet usually takes longer than reworking the figure itself.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
