Panzerkraft 1:35 door stoppers with a weld seam, pattern 2 are resin (3D-printed) detail parts for superdetailing models of the Panzer III tank, with enough material for up to ten vehicles.
Responsibility details are not available.
This is a fine aftermarket detail set, not a kit. The package contains a set of resin (3D-printed) hatch door stoppers for a model of the Panzer III tank in 1:35 scale. The parts faithfully reproduce both the small stopper and the realistic weld seam that plastic parts normally lack. The quantity is worked out to be enough for roughly ten vehicles, so the set will serve on several models or across a whole column.
Hatch stoppers are among the details that raise the credibility of a whole model at first glance. Pattern 2 matches one of the production variants of the fitting. The parts replace or supplement the details of the basic kit and are meant for modelers who want to take the fidelity of their Panzer III to a higher level.
First wash any print resin residue off the resin parts and separate them carefully from the print supports. They are glued with cyanoacrylate glue (super glue). Protect your airways while sanding. Before applying paint, it is advisable to spray the parts with a primer.
This is an add-on resin detail set. Glue, paints and the base model are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
