PLIER CUTTING TOOL

AK Interactive sprue cutters

Sprue cutters (nippers) intended for modelers, for separating parts from the sprues accurately. A handle with a non-slip finish and a return spring makes for comfortable, controlled work. The cutting edge produces a clean cut in plastic with a minimum of burrs, so only a little cleaning up is needed. Suitable for plastic, resin and similar softer parts; they are not intended for cutting metal. Made by AK Interactive.

Use

• Separating plastic parts from the sprues
• Trimming pins and the remains of sprue gates cleanly, close to the part
• Trimming resin and ABS parts of smaller cross section
• Preparing parts for gluing with a minimum of cleaning up afterwards

Who they are for

Basic equipment for every plastic modeler, from beginners to advanced builders who want to separate parts cleanly and gently, without stressing the material.

The cutting edge is very sharp, so work carefully, direct the cut away from your fingers and do not use the cutters on metal or hard wire, to avoid damaging the jaws and to avoid injury.