The DSPIAE 2.7 mm tungsten steel drill bit is a bit for plastic models in a heavier diameter, ideal for larger holes and mounting.
Responsibility details are not available.
A tungsten steel drill bit of 2.7 mm diameter for drilling into plastic models and soft materials. Tungsten steel is very hard and holds its edge for a long time, while the generous room for chip clearance lowers the resistance as it bites into plastic. The hole comes out clean and accurate, without melting or fraying. This heavier diameter is intended for larger holes and load-bearing mounts.
For modelers who need accurate holes of a larger diameter. Tell the bits apart by diameter; this one is 2.7 mm.
Drill slowly and without side pressure; hard tungsten steel is brittle and can break if levered or bent. At this heavier diameter, pilot-drill the hole with a smaller bit first.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
