A fine sheet with lengthwise V-grooves every 0.64 mm. Only half a millimeter thick, format 15 x 30 cm.
Responsibility details are not available.
The lengthwise V-shaped grooves follow one another every 0.64 mm, which is the conversion of twenty-five thousandths of an inch. The sheet is half a millimeter thick, so it can be cut with scissors, bent over the edge of a ruler and glued even onto a curved surface. The longer side of the sheet measures thirty centimeters, the shorter fifteen.
In 1:72 scale one groove corresponds to a strip 4.6 cm wide, in 1:48 to three centimeters and in one thirty-fifth to only 2.2 cm. This is the material for the floor of a cab, the bed of a truck, the cladding of a ship superstructure in a small scale or the wall of a crate. Where a coarser grid would immediately give away the wrong scale, this spacing holds the scene together.
A thin sheet deforms easily with heat, so do not bond it with super glue over a large area all at once. It is better to apply a thin layer of liquid cement along the edges and weigh the surface down with a book until the joint has dried. When cutting, lead the knife parallel with the grooves, or the blade will slide into a groove and the cut will wander. Apply the paint thinned; a thick coat fills the grooves and the texture disappears. The remaining offcuts come in handy for small things: a strip two millimeters wide makes a hatch, a small crate or the lid of a box with a wooden surface.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
