Very smooth saw (both sides) 1pc

Very smooth saw (both sides) — a double-edged CMK saw blade

A thin modeling saw blade from CMK with fine (very smooth) teeth on both long edges. The double-edged toothing makes it possible to cut on the pull as well as on the push stroke and to use both sides of the blade, which extends its life and makes work in various positions and angles easier. The fine teeth leave a smooth cut with a narrow kerf and a minimum of burrs. It is not a kit or a model, it is a modeling tool.

Use and tips

• Thanks to the teeth on both edges you can cut in both directions — it suits tight places and cuts from inside an opening.
• Watch out for the upper edge: while guiding the cut, do not lay it on finished parts, so as not to damage them.
• Suitable for injection-molded plastic as well as resin — clean separation of parts and fine grooves.
• First score the cut and then deepen it; cut with light strokes and do not overload the thin blade with sideways pressure.
• Once one edge is worn, you can carry on with the other side of the blade.

Who it is for

For modelers who need a fine cut and will appreciate being able to cut from both sides of the blade — work in tight places, conversions and precise reworking of parts. The double-edged design is practical where the tool is awkward to turn and it helps to change the direction of the stroke.

This is a tool, not a kit. Both edges are sharp, so handle it with care.