1:48 Boeing CH-47A Chinook is an Eduard photo-etched detail set for a kit of the twin-rotor Chinook helicopter in 1:48 scale. It is an accessory to a kit, not a model of the helicopter.
Responsibility details are not available.
A set of photo-etched parts in thin metal sheet intended for refining a kit of the heavy transport helicopter CH-47A in 1:48 scale. The package does not hold a model of the helicopter; it is an accessory to a kit you have already bought. The maker is the Czech firm Eduard. The particular make-up of the parts is not stated here.
The CH-47A Chinook is the first production version of the heavy transport helicopter with a tandem arrangement of two lifting rotors. The layout without a tail rotor makes it possible to use the full power of both turboshaft engines for carrying a load and gives the helicopter a wide permissible range of center of gravity. The fuselage has a rectangular cross section with a cargo compartment along its whole length and with a hinged ramp at the rear. In 1:48 scale the Chinook is a large model with long flat surfaces, on which every thick-walled part shows at first glance.
Separate the parts with a scalpel on a hard surface and degrease them, otherwise metal glues and paints badly. Bend longer straight parts in a modeling bender; on a large fuselage it pays to offer each part up dry first and check whether it seats into the engraved lines. It is glued with cyanoacrylate glue in a minimal quantity. The places where photo-etched parts go usually call for the original plastic relief to be cut away and the area leveled with abrasive paper.
The accessory set is supplied without a kit, glue or paints.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
