A British wicker seat with a full back 1:72, the low one with a small and the tall one with a big leather pad, is a resin accessory for the cockpit that replaces the simplified plastic part from the kit.
Responsibility details are not available.
A resin accessory for the interior in the small scale, not a kit of an aircraft. The set contains a low seat with a small leather pad and a tall seat with a big pad. The back is full in both cases.
The difference between a low and a tall seat is more visible on a model than one expects: a tall back reaches into the view out of the cockpit and changes the silhouette of the space behind the pilot, while a low one lets the rear bulkhead stand out. A plastic kit usually offers only one variant and its leather pad is suggested by engraving. The resin castings offer both heights and a pad with an edge of its own, which can be separated during the painting.
Do the dry fit before you reach for the glue. In a narrow fuselage the tall seat often bears against the top edge of the side wall and the fuselage then cannot be closed. Slide the part into place without glue, therefore, join the fuselage halves with a rubber band and look against the light to see whether the joint fails to hold anywhere. When the clearance is small, it is enough to sand the lower edge of the seat down or to thin the inner side of the side wall, rather than to sacrifice the whole part.
This is an accessory for a model, not a kit in its own right. The parts are supplied unpainted; glue, paints and other accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
