The Tamiya Screwdriver No.2 L is a size 2 Phillips screwdriver with a long, slim shaft. The blade is chrome vanadium steel and handles screws 3 to 5 mm in diameter.
Responsibility details are not available.
A Phillips screwdriver from the Tamiya range of modeling tools. The designation No.2 gives the tip size, the letter L the longer version, and the plus sign says that the tip is cross-shaped rather than flat. The blade is impact-resistant chrome vanadium steel and the shaft is 5 mm across, so it reaches into deeper holes and gets to screws surrounded by plastic.
Where it is used
Size 2 matches screws roughly 3 to 5 mm in diameter. That is the typical range on models driven by an electric motor, on sets with gearboxes and on structural parts where plastic is screwed together instead of glued. It also earns its place in everyday workshop maintenance, on a compressor, a stand, a lamp or the screws of a display case base.
For modelers who also build powered and mechanical sets, and for anyone who wants a screwdriver in the workshop that matches modeling screws, since an ordinary workshop one tends to be too coarse for the job. The smaller size in the same range suits finer screws, so the two sizes complement each other on the bench.
The tip is hard and can damage a screw head under angled pressure. Hold the screwdriver in line with the screw and do not use it as a pry bar.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
