A coffin in 1:48 scale is a scenic accessory for a diorama, not a vehicle kit and not a figure. It will complete civilian and historical views in which a scene is meant to have a clear story.
Responsibility details are not available.
A prop in its own right for a scene in 1:48 scale. It is not a model of a vehicle or an aircraft and cannot be built as an exhibit on its own: it is an element that is added to a diorama already under way and gives it a definite content. The 1:48 scale is the scale usual with aircraft and with more compact scenes, where the balance between detail and the area taken up is watched.
It comes into its own in civilian and historical views: a village green, a city street, a churchyard, a rear area away from the fighting line. In a scene it works as an anchor that the placing of the figures and the direction of their gaze relate to. The subject calls for a sparing treatment: the fewer other props around it, the more readable the view stays.
Before painting, wash the part in lukewarm water with a drop of dish soap and let it dry through; settled dust and grease tend to be the most common cause of poor paint adhesion. Then comes a thin base, and only after it the shade of wood or finish. In 1:48 scale a part is noticeably smaller than in 1:35. Paint with a fine-tipped brush and rather twice thinly than once thickly, as a heavy coat clogs the fine surface here. Apply the wash sparingly and blot the excess at once. Set the accessory onto the base so that it sits down across its whole area; a gap underneath gives a part stuck on afterwards away at once.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
