Wheels in the Work Emotion CR Kai pattern 18 inches in diameter in 1:24 scale. An accessory for swapping the wheels on an automobile model.
Responsibility details are not available.
The Emotion CR Kai pattern comes from the range of the Japanese make Work, which is among the typical suppliers of wheels for modified cars from Japan. An eighteen-inch diameter corresponds in 1:24 scale to roughly 19 mm, that is to a size that comes across as full in the arch but still leaves the tire an apparent sidewall.
These are wheels of the Emotion CR Kai pattern intended to be swapped for the parts from the box. They suit builds of Japanese cars and dioramas where the car is in the foreground and the wheels are seen close up. The extent of the package, how the parts are divided and the recommended glue are given in the instructions enclosed by the manufacturer.
Before you fix the wheel, seat it dry and check that the diameter, the width and the track fit and that the wheel turns freely, if the build assumes that. Cut the excess material away with a sharp blade a little from the part and sand the surface by which the wheel seats level. Wash and degrease the parts before painting. A light metallic shade of the spokes comes out when a darker tone is laid into the hollows between them; leave the edges clean while doing it.
The wheels will be appreciated by modelers who build modern automobiles in 1:24 scale and want to bring them into line with the appearance of a particular modification. It is an accessory to building a model: paints, glue and tools do not belong to it, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
