RIVETER TRIPLE 0.55 MM is a three-row riveting wheel for imitating rivet rows on plastic models. The figure of 0.55 mm from the name identifies the version within the range.
Responsibility details are not available.
A three-row riveting wheel for imitating rivet rows in plastic. It is not a kit and not an accessory to one particular model, but a workshop tool that will last for dozens of builds. The designation TRIPLE corresponds to the three-row version; the brand distinguishes the single-row and two-row versions in the same way. The figure of 0.55 mm in the name tells the individual sizes in the range apart: a lower value means a finer track, a higher one a coarser track. This version belongs to the fine part of the range.
The finer end of the range will be appreciated by modelers who work in smaller scales and on surfaces with dense riveting: wing skins, panel divisions on fuselages, engine covers. This is exactly where the difference between a scribed line and a readable rivet row shows most, because the surface is not crowded and every mark is visible. The three-row version saves time everywhere the rivets run in a bunch side by side and a single-row wheel would mean three separate passes with the risk that the rows drift apart.
With fine tracks it pays to spray thin. A heavy coat of undercoat can fill the small dimples so much that they practically disappear once dry.
Care: keep the working part clean and dry and store the tool so that it does not get knocked about against other tools. The box holds the riveting wheel itself; plastic, templates and paints are not included.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
