1:35 Printed Accessories: Wall and Floor Tiles Nr.11 is a printed RT-Diorama accessory for a diorama in 1:35 scale - wall and floor tiles for a model interior.
Responsibility details are not available.
What is offered here is a printed diorama accessory from RT-Diorama in 1:35 scale - a pattern of wall and floor tiles listed under the sequence number 11. It is a flat element of the equipment of a scene, not a kit of a building and not a model of equipment.
Floor and wall tiles do a double job in a diorama. Firstly they settle the scale, because the viewer unwittingly converts regular joints into the real size. Secondly they give away the function of a room sooner than anything else - a tiled wall says immediately that this is a bathroom, a kitchen, a butcher's shop or public back rooms, and a builder thereby saves a whole lot of small props that would carry the same information less well.
Lay the area out before you fit it: decide where the cut at the wall will be, where the wall tiles will end and where another surface follows on above them. The transition between the tiles and the wall above them is the detail that does an interior the greatest service, and it is worth giving it time. Wear the surface down in the places walked through and add dust along the walls. When the scene is damaged, loosen a few tiles at the edge of a hole and scatter them into the rubble - nothing comes across more believably than an area that falls apart gradually rather than along a straight line.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
