Hose joints of 1.2 mm diameter is a set of detail parts for faithful hose and line runs in vehicle models.
Responsibility details are not available.
A set of tiny joints and end fittings meant for hoses of 1.2 millimeters outside diameter. They serve to imitate the threaded joints used in racing cars on fuel, brake and cooling lines. The package holds several kinds of part in various numbers, so a whole run can be put together, not just a single joint. It is not a kit but a detail accessory.
Try the hose and the joint dry first and only then settle the length. Cut the ends of the hose square with a fresh blade, as an angled cut sits crooked in the joint. The best procedure is to paint the joint before fitting it, because once assembled you cannot get to it with a brush. A metallic shade on the joint shows best against a dark hose. It is glued with super glue dosed with a pin.
The set is supplied on its own; a model and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
