Nuts with Screw Stem and Washer 1.5 mm (1/35)

The heaviest size in the whole line

One and a half millimeters is the largest of the sizes offered, and in 1:35 scale it matches genuinely massive joints. Nuts like these hold front armor plates, lifting lugs, the mountings of final drives, or flanges that a shaft passes through. These are the places a viewer looks at closely on a finished model, because that is exactly where the impression breaks or holds, whether the vehicle looks like a machine or like a toy.

The shape of the part

Under the nut there is a washer, and above it a short piece of the threaded part projects. That overhang matters in fact: on large joints a bolt is never cut off flush, and a projecting end is one of the first clues by which the eye tells a real fastener from a mere bump.

Where to use it

1:35 is the royal scale for tracked and wheeled vehicles, for artillery and for industrial machinery in dioramas. Use it on the flanges of engine covers, on the feet of frames, at the drawbar couplings of trailers and anywhere you want to say that a part can be unbolted.

Procedure and spacing

The layout matters more than the part itself. Real joints tend to be spaced regularly around a circle or in a row, so sketch out the spacing first and only then drill. A shallow dimple holds the part in the right position until a drop of thin glue sets. Once dry, sand the spot only very lightly, so that the nut does not lose its edges. It pays to try the procedure out beforehand on an offcut of plastic.