The middle fine value of the bulletproof family. Seven tenths of a millimeter suits places where the joint is to be distinct but must not suppress the surrounding shaping.
Responsibility details are not available.
Seven tenths of a millimeter lies in the band where the builder first has to decide consciously. The smaller values forgive, because they are lost in the paint; this one no longer does: once you can see the part on the model, you can also see whether it fits. With this size it therefore pays to devote a moment to the subject before you reach for the pot of glue.
The surest proof tends not to be where the builder looks for it. A bolt passes right through the material and something protrudes from it on the far side, most often a nut, sometimes just the end of the shank. A rivet, by contrast, creates a head on both sides, but the second head is closed and differs in shape from the front one. So when you have a shot from inside the fighting compartment or from the back of a panel at your disposal, the question is settled in a second.
On a model this insight has a direct consequence. If you are building an open interior, the joint should appear on both sides of the wall, and in corresponding places. A number of otherwise fine builds founder precisely on the outer surface being studded with fasteners while the inner wall was left smooth. A few parts in the right places are enough, though: completeness is not what decides here, what decides is the match of positions on both sides.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
