A resin ejection seat with belts for the F-16A/C Fighting Falcon in 1:72 scale from Quickboost — a precise detail accessory; it is not an aircraft model.
Responsibility details are not available.
A resin ejection seat with molded safety belts from Quickboost for the American F-16A/C Fighting Falcon fighter in 1:72 scale. It is not an airplane model, but a precise replacement part for more experienced modelers that replaces the simplified plastic seat from the kit with a casting with a faithful texture and finely rendered straps. Under the large bubble canopy of the F-16 the seat is superbly visible, so a faithful part lifts the impression of the cockpit decisively.
The F-16 is a single-seat light multirole fighter with a markedly reclined ejection seat and a roomy cockpit under a one-piece canopy. The plastic seat tends to be molded flat and without belts. The resin replacement with rendered straps looks realistic even without photo-etched accessories. The part is meant to refine an existing F-16 model in the same scale.
Wash the resin part in lukewarm soapy water to remove the mold release residue from the mold. Cut the casting block off with a sharp knife or a fine saw and clean up the surface; protect your airways when sanding resin. Glue with cyanoacrylate glue. Paint the seat and bring out the belts in a different shade; the fine stitching shows up after light toning.
It is supplied as an unpainted resin accessory for completing a model. Glue, paints and the model itself are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
