Reskit AGM-12B Bullpup A missiles 1:72 is a 3D-printed resin set of two air-to-ground guided missiles for jet aircraft; it is a detail accessory to a kit, not an aircraft model.
Responsibility details are not available.
A resin, 3D-printed detail set from Reskit containing two AGM-12B Bullpup A air-to-ground guided missiles in 1:72 scale. The missiles are meant to be hung under the wings and fuselages of jet aircraft and markedly raise the realism of a model's armament. This is not an aircraft model but a detail accessory.
The AGM-12 Bullpup was one of the first tactical air-to-ground guided missiles fielded in quantity, in use from the late 1950s. After launch the pilot steered it manually onto the target by the flare in the tail of the missile. The Bullpup A version was one of the smaller and widespread designs and was carried by a number of combat jets of American and allied manufacture.
First wash the resin and 3D-printed parts to remove any uncured print resin, cut off the print supports and sand the surfaces with your airways protected. Bond with super glue (cyanoacrylate). Apply a primer before painting; missiles usually carry a light base finish with colored marking bands, which come out well after shading and light weathering.
This is a detail accessory, not a complete model. Paints, glue and the base kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
