The KM-1 ejection seat in 1:32 scale is a 3D printed accessory from Temp Models. It replaces the seat from the kit and raises the level of detail in the cockpit.
Responsibility details are not available.
The set brings a 3D printed KM-1 ejection seat in 1:32 scale from Temp Models. It is not a model of an aircraft but a replacement for a cockpit part: the printed seat carries sharper detail of the harness straps, the restraints and the controls than injection-molded plastic can give. It goes in place of the part from the kit, or into the open cockpit of an older fighter.
The KM-1 is an ejection seat of an earlier generation, which entered Soviet aircraft in the 1960s. Against the later K-36 family it has simpler stabilization and a narrower range of conditions under which it can save the pilot. It was carried by the MiG-21, the MiG-23, the MiG-25 and the MiG-27 in various versions, that is by the machines that formed the backbone of Soviet tactical aviation.
The parts are printed from resin and are held only by thin supports. Cut them off with a sharp scalpel as close to the part as possible, sand the marks down with fine sandpaper and protect your airways while sanding. It is glued with cyanoacrylate glue (super glue). Paint holds longer on a smooth print if you lay a thin coat of primer under it. Paint and weather the seat before gluing it into the cockpit, because afterwards you will not reach it.
The set is an addition to building a model, not a model in its own right. It is supplied unassembled and unpainted, and glue, paints and the base kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
