Landing gear wheels for the MiG-15 in 1:32 scale are a 3D printed replacement for the parts from the kit, from Temp Models. It is not a model of the aircraft but an accessory for a build.
Responsibility details are not available.
The set brings 3D printed landing gear wheels for the MiG-15 in 1:32 scale from Temp Models. It is not a model of the aircraft but a replacement for the parts from the kit: the printed wheel carries a crisper tread pattern, finer relief on the hub and a cleaner shape of the axle boss than an injection mold can give. For the sets of this range the manufacturer gives the nose wheel and the braked main wheels.
The MiG-15 is a single-engine jet fighter of the late 1940s with a swept wing and a stepped fuselage. It was built in enormous numbers and under license in Czechoslovakia as well, where it flew under the designation S-102. Its landing gear is short and sturdy, because the aircraft was built for operation from grass and simply surfaced strips too, and that is exactly why its wheels are conspicuously heavy in proportion to the small airframe.
The parts are printed from resin and are held only by thin supports. Cut them off with a sharp scalpel as close to the part as possible, sand the marks down with fine sandpaper and protect your airways while sanding. It is glued with cyanoacrylate glue (super glue). Paint holds longer on a smooth print if you lay a thin coat of primer under it. Paint the wheel in stages: the hub first, then mask it and finish the tire. Dust pigment holds in the tread pattern on its own.
The set is an addition to building a model, not a model in its own right. It is supplied unassembled and unpainted, and glue, paints and the base kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
