Landing gear legs for the Su-33 in 1:48 scale are a 3D-printed resin accessory from Temp Models, reinforced with steel pins.
Responsibility details are not available.
A resin set of landing gear legs for a model of the Su-33 carrier fighter in 1:48 scale from the Russian brand Temp Models. For the sets in this series the manufacturer states printing from a strong polymer reinforced with steel pins, and the extended position with the lines, the landing lights and a fender picked out. It is not an aircraft kit but replacement parts for your own model.
The Su-33 launches from a deck over a ski-jump ramp and lands onto arresting wires, so its landing gear takes incomparably harder treatment than on the land-based version: the machine touches down with its full weight and without a flare. The structure is therefore markedly reinforced and it differs from the land-based Su-27. It is exactly this difference that is one of the details worth attention on a model of the carrier version.
Release the parts from the supports with a scalpel and level the mating faces. Wash the resin in lukewarm soapy water before painting. Spray the legs before fitting and bring the lines out with a dark tone. On carrier hardware, weathering that leans toward gray suits the model, matching the salt haze, with a hint of corrosion on the edges.
The set is supplied unassembled and unpainted. The model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
