Etch Slide Change Parts 9

Replacement part from the Etch Slide range, number 9

This is a replacement part of the Etch Slide range, which carries the number 9. It is supplied on its own and is used to complete what you already have; it is not a kit and not a finished model. Cutting blades belong to the Etch Slide tool range, so the replacement parts belong to the same range.

The number nine within the range

The number tells the individual parts apart from each other and does not denote the size, the material or a scale. What they differ in is given in the manufacturer's instructions. Check the number you need against them before you order the part.

Handling and care

A thin metal part stands a lot across its face, but it bends over an edge even when you do not want it to, and getting it back flat is not possible. Work on a hard flat surface and pick it up with pointed tweezers rather than with your fingers: grease stays on metal. After use, wipe it dry and store it flat, so that it does not warp. The edges may be sharp, so count on that when handling it.

• a replacement part of the Etch Slide range, number 9
• the number tells the individual parts of the range apart
• a thin metal part, it bends easily and does not straighten back
• wipe it dry and store it flat
• the use and the procedure are described in the manufacturer's instructions

Who it suits

The part will be used by someone who already has the Etch Slide range and needs to complete it or to replace a worn piece. You will find the use and the procedure in the manufacturer's instructions. The package contains the replacement part listed under the number 9; nothing else is part of the delivery, unless stated otherwise.