A hand saw with interchangeable blades, a set of eight pieces from Model Craft. Various blades for cutting plastic, wood and soft metal.
Responsibility details are not available.
A hand saw with a handle and a set of eight interchangeable blades. A saw is a tool used in a modeling workshop less often than a knife, but at the moment it is needed nothing replaces it: for cutting a casting block off a resin part, for parting a thick profile or for cutting through a joint that will not break apart.
The set of blades with various toothing makes it possible to work with plastic, with wood and with soft metals. Most often the saw is used for cutting casting blocks off resin parts, for shortening profiles and rods, for parting metal barrels and for opening glued joints when repairing older models.
Cut on the pull, not by pressing, and let the toothing itself do the work; pressure leads to a slip and to damage to the part. Always clamp the part or support it firmly. With resin cut slowly and level the surface afterward with sandpaper. When cutting resin and metal protect your airways, because a fine dust is created.
When cutting resin and metal use respiratory protection and work in a ventilated room.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
