Tamiya Sanding Sponge Sheet, 320 grit is a flexible sanding sponge in 320 grit for removing flash and casting blocks and for leveling filler. A modeling aid, not a kit.
Responsibility details are not available.
This is a modeling tool, not a kit. The abrasive is bonded to a flexible sponge backing, so the sheet is not rigid like sandpaper: it bends and follows the shape of the surface. That is a decisive advantage on rounded parts such as fuselages, cowlings, turrets and the helmets of figures, where rigid paper easily takes down an edge or sands a flat spot. The sponge can be cut into smaller pieces as needed and it reaches into places that are harder to get at.
With abrasives a simple rule applies: a lower number means a coarser abrasive, a higher number a finer one. Grit 320 belongs among the coarser ones and is intended for removing material, not for finishing. You always work from a coarser grit to a finer one: the coarse one does the job, the fine one then smooths out the scratches left by the coarse one. The other way round does not work: a fine abrasive will not smooth out the scratches left by a coarse one, it will only polish them and make them more visible. After sanding with 320 grit, always continue with a finer abrasive before you put primer or varnish on the surface.
For every modeler who builds plastic kits and needs to prepare a clean surface before painting. The aid also suits beginners: a rounded shape is harder to spoil with a sponge than with rigid sandpaper.
A modeling aid. Do not inhale the sanding dust: use respiratory protection, work in a ventilated area and ideally sand wet. Keep out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
