A resin set of triangular nuts for German Second World War vehicles, 1:16 scale — small fastening details, not a kit.
Responsibility details are not available.
A set of very small resin castings replacing the characteristic triangular nuts that appear in a number of places on German Second World War vehicles. This is purely a detailing accessory, not a kit and not a conversion set.
The triangular nut is one of those elements that keep coming back in photographs: it holds tool clamps, plates, brackets and other fittings on the hull, so there are a great many of them all over one machine. And because they sit on visible surfaces, it is precisely they that make the surface of a model rich. A plastic kit molds them at the same time as the plate they sit on, so they come out low and with soft corners — and if you sand a seam near them, they disappear altogether. In a large scale, meanwhile, a nut has distinctly sharp corners and a head standing proud of its seat.
These are the smallest parts cast in resin, so have a tray with a raised edge, tweezers with fine points and a new blade ready. First wash the castings in warm water with detergent, then cut them off the casting frame with a drawing motion; never snap them off. They are glued to the model with a spot of cyanoacrylate glue applied with a pin — a drop from the bottle would drown the nut. It helps to mark the position lightly beforehand and to seat the nuts one at a time.
The accessory is supplied unpainted. Glue, paints and the base kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
